Bottom Prep Fiberglass Dewaxer D95, Quart - Pettit Paint
- Removes Fiberglass Mold Release Wax
- Used Above or Below the Waterline
GENERAL DESCRIPTION
Prior to any surface preparation, all bare fiberglass must be thoroughly washed to remove mold release waxes used in manufacture. 95 Fiberglass Dewaxer is a special blend of solvents, formulated to cut through and remove mold release, grease, and previously applied waxes from the gelcoat.
Liberally wash the surface to be painted with clean rags, changing the rags frequently to prevent merely smearing around the waxes. Run water over the hull to check if all wax has been removed.
Strips off old wax and etches surface for excellent paint adhesion. Approximate coverage per gallon: 400 sq. ft.
Disclaimer: Charts apply to Interlux products only. The information provided is not intended to be exhaustive. Because iboats.com does not know how this information is being used, they cannot take responsibility for any actions as a result.
The performance of marine paint relies on many factors outside the control of iboats.com, including surface preparation, proper application, and environmental conditions. Therefore, iboats.com cannot guarantee this product's suitability for your particular purpose or application.
By purchase or use of this product, buyer agrees that the sole and exclusive remedy, if any, is limited to the refund of the purchase price or replacement of the product at iboats.com's option.