Attwood Universal Fuel Line Assemblies

A good replacement hose.

I had a problem with the previous hose in that the hose had a liner inside the hose that when the end fitting was inserted, the liner came loose and almost blocked the hose. This caused quite a bit of troubleshooting because the outboard would not reach full RPMs. Problem was not evident just looking at the hose. I didn't find this until I replaced the hose because the bulb was starting to crack. This hose does not have the liner in it to cause this problem.

My old (1988) original Force outboard fuel lines were damaged from ethanol fuel, which they were never designed for. Replaced/upgraded using this kit which includes new style dual layer primer bulb (pre-installed) and new male and female quick-connect tank fittings. Female fitting is pre-installed on fuel line, simply install (thread) male end into your new or existing fuel tank fitting and go! Be sure to use thread sealant on male fitting threads. No spray, but I personally recommend releasing pressure from tank by slowly unscrewing gas cap before connecting/disconnecting fuel line to prevent any spillage from tank pressure. Also purchased Attwood Fuel Demand Valve for a complete job, prevents tank pressure from flooding engine when turned off. Works great.